» Topic: App crashed now my file won't open!
- June 7, 2014 at 3:07 am #18543
Hello. I have ben designing an object for hours and had been saving the file under a few different names and when I got to about 98% completion BobCam V25 crashed and when I re-launched the program it will not open my file anymore. It instantly searches for a solution and shuts down. It corrupted the file I was working on and none of the other that I thought I was saving are there, it is like it deleted them all when the application crashed. Several hours down the bleepin’ drain. Is there any hope of opening the file?June 7, 2014 at 3:28 am #18544
did you look here: C drive/BobCAD CAM Data/BobCAD CAM V25/Back-upJune 7, 2014 at 3:33 am #18545
Yes, I just found the folder and the backup that is in there is corrupted also.June 7, 2014 at 3:39 am #18546
I was just about to cleanup/optimize the project and call it quits for the night when the application shutdown and corrupted the file. It looks like I will probably have to start over, and I was so close to finishing the design part of the project. I wish there was another application that could open *.bbcd files.June 7, 2014 at 4:03 am #18547
Instead of opening from the file icon,,open up V 25 then go to file / open.
One time I recently have done similar.Usually when you are struggling or having to do things twice.Your loosing your groove of work,things not flowing right,,seems the model gets heavier and heavier and then it freezes.
You get a feeling when it is time to redo from scratch and it will go fast this time and CLEAN,,,,then continue on where you were.Lot to be said about clean geometry and a correct execution of commands.
Another thing that messes me up the most is my graphics card is middle of the road.That will present it’s own set off problems,Need some pretty big resources for some files.
Seen some BoB stuff done a super modified computer,quite the difference in how it handled crunching the data.So there are some thing I try to avoid or make better.
I always do some moves slow,like selecting geometry,pause/then ok.Sometimes you rush these calculations,trouble follow.June 7, 2014 at 4:41 am #18548
Thanks for the suggestion. I tried opening from the file menu and it still crashes the program. It shows a preview of the file but will not open. The application seemed to really do a number on the file.June 7, 2014 at 4:55 am #18549
try .zip the .bbcd file here.I can give a try.
You must be logged in to reply to this topic.
- Bobcad V23 4 axis arc issues by spach2318 hours, 49 minutes ago
- Ball nose tools into tight corner features by Barrie2 weeks ago
- Load a V carve tool into 3 axis operation by mgdpapa1 month, 2 weeks ago
- version 28 large NC file when posted by [email protected]1 month, 1 week ago
- error r6025/bobcad v27 glitches w/windows10 by jakeg1 month, 2 weeks ago