Open Source Sofware

» Topic: changing post

Home New Forums BobCAD-CAM Forums changing post

This topic contains 3 replies, has 2 voices, and was last updated by  Sean Owen 3 years, 4 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #12568

    shawn
    Participant

    I have downloaded the post for Mazak machines. How do i change the post to post out so it works for the machines we have? It only need slight changes to the start and end of the program

    #12679

    Sean Owen
    Blocked

    This video should help , its for an older version but the steps are the same…
    http://www.youtube.com/watch?v=0LZr7I5lTH8

    #14211

    shawn
    Participant

    the video is for v23,, will the same options work on v3?

    #14218

    Sean Owen
    Blocked

    Yes, its for an older version but the steps are the same…

    The Post Processors are the same for BobCAD & BobCAM.

    • This reply was modified 3 years, 4 months ago by  Sean Owen.
    • This reply was modified 3 years, 4 months ago by  Sean Owen.
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.

Forum Account

     Lost Password / Register   

Sharing

facebooktwittergoogle_pluspinterestlinkedinmail