Open Source Sofware

» Topic: Deleting duplicate toolpaths

Home New Forums BobCAD-CAM Forums Deleting duplicate toolpaths

This topic contains 1 reply, has 2 voices, and was last updated by  Darren 2 years, 9 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #16403

    Zeke
    Participant

    I created a facing toolpath, but the rough & finish paths are exactly the same. How can I delete either the rough or the finish path?

    #16404

    Darren
    Participant

    Zeke, If you are using V25 or down to V23, Then on the finish tool, put a zero value in the diameter. If using V26 the you delete the finish strategy or X out of this. Give this a try

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Forum Account

     Lost Password / Register   

Sharing

facebooktwittergoogle_pluspinterestlinkedinmail