Open Source Sofware

Incremental output

Home New Forums BobCAD-CAM Forums Incremental output

This topic contains 1 reply, has 2 voices, and was last updated by  Sean 3 years, 1 month ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #18074


    How can I get V23 to output the moves in incremental?

    I have tried selecting the “Incremental” button on the Milling Tools > Current Settings > Posting dialog, and I have changed the 511 line in the post processor, but neither has any effect.




    You would have to change block 2-4. Anywhere where absolute_coord is set would have to be changed to incremental_coord.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.