Open Source Sofware

» Topic: Multiple chamfers

Home New Forums BobCAD-CAM Forums Multiple chamfers

This topic contains 1 reply, has 2 voices, and was last updated by  RAF 2 years ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #19688

    Randy
    Participant

    I am trying to do multiple chamfers on a slot and not all chamfers end up on the proper side. I have tried doing them all at once and individual and get the same results.
    Attached is the file. You can see the path is wrong on the top left side

    #19689

    RAF
    Participant

    not seeing any attachment Randy

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Forum Account

     Lost Password / Register   

Sharing

facebooktwittergoogle_pluspinterestlinkedinmail