Open Source Sofware

» Topic: open wall on 2d pocket milling

Home New Forums BobCAD-CAM Forums open wall on 2d pocket milling

This topic contains 1 reply, has 2 voices, and was last updated by  Sean 2 years, 5 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #17421

    Drew
    Participant

    Bobcad will recognize that an edge of a face is the edge of the part and cut off the end of it with pocket milling. How is it done?

    #17811

    Sean
    Participant

    Drew,

    What version are you working with? If you are not on V25 or above, then you will not have the capability to do open sided pocketing. If you have V25 and above, then you will make the open sides into dashed lines using one of the dashed line styles available. You would then use the advanced pocketing function which will recognize those dashed lines as open sides.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Forum Account

     Lost Password / Register   

Sharing

facebooktwittergoogle_pluspinterestlinkedinmail