Open Source Sofware

» Topic: outside and inside oring groove on mill

Home New Forums BobCAD-CAM Forums outside and inside oring groove on mill

This topic contains 15 replies, has 4 voices, and was last updated by  Sean 2 years, 2 months ago.

Viewing 16 post (of 16 total)
  • Author
    Posts
  • #18910

    Sean
    Participant

    Micah,

    V25 does not have the capability to simulate with a t-slot cutter with the profile tool path. The functionality was not added until V26. If you want this functionality, you would have to upgrade to V26.

Viewing 16 post (of 16 total)

You must be logged in to reply to this topic.

Forum Account

     Lost Password / Register   

Sharing

facebooktwittergoogle_pluspinterestlinkedinmail