Open Source Sofware

Plunge Feedrate for Laser Setup

Home New Forums BobCAD-CAM Forums Plunge Feedrate for Laser Setup

This topic contains 0 replies, has 1 voice, and was last updated by  Jevon 2 years, 7 months ago.

Viewing 1 post (of 1 total)
  • Author
  • #20296


    Does anyone know how I can change the z-axis plunge feedrate when BobCAD is configured for Laser cutting? The default value I’m getting is 0.015 ipm which makes the calculated cycle time extremely long. I can’t find anywhere that I can change this value.

    Now, I could just change my feed plane and total depth so I don’t have any z-axis feed moves, but I use the z-axis feed to turn the laser on in the post-processor.

    Am I missing something? Thanks,


Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.