Open Source Sofware

» Topic: Set up new CNC mill. . .

Home New Forums BobCAD-CAM Forums Set up new CNC mill. . .

This topic contains 1 reply, has 2 voices, and was last updated by  Sean 2 years, 4 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #18984

    Mike
    Participant

    I have a Tree Journeyman 325 CNC mill and I want to use BobCad for my design but it is not listed as an available mills within BobCad. What do I do or what settings can I use to make my mill work???

    Thanks for the help!

    Mike

    #19010

    Sean
    Participant

    Mike,

    The mill itself will not be what displays for available post processor. All of our post processors are listed based on controllers, so you would want to find a post processor that shares the same make as the controller.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Forum Account

     Lost Password / Register   

Sharing

facebooktwittergoogle_pluspinterestlinkedinmail