Open Source Sofware

V 27 MISSING SEGMENTS WHILE ENGRAVING

Home New Forums BobCAD-CAM Forums V 27 MISSING SEGMENTS WHILE ENGRAVING

This topic contains 2 replies, has 2 voices, and was last updated by  Gerald 1 month ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #32886

    Gerald
    Participant

    Yesterday I built 2 programs and in simulation it skipped cutting some top segments and some bottom segments.
    I shut the computer down for the night and they are still the same. I did erase doubles and also cleanup / optimize.
    I am afraid to run the program to see if it actually skips in the cut.
    Any suggestions?
    I attached 1 of the files.

    #32909

    jrmach
    Participant

    file ?

    #32912

    Gerald
    Participant

    I called tech support and they helped me figure a way around the problem. I had to explode and then select the missing legs and cut then seperatly.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.