Open Source Sofware

» Topic: V25 on a Haas TL1 Lathe

Home New Forums BobCAD-CAM Forums V25 on a Haas TL1 Lathe

This topic contains 2 replies, has 3 voices, and was last updated by  Jason 2 years, 11 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #16401

    Jason
    Participant

    Has anyone used BobCAD-CAM V25 on a Haas TL1 Lathe?

    Is there anything I need to know about making my tool paths go in the negative direction?

    #16406

    Mike
    Participant

    As long as you Draw your part in the correct Origins, the toolpath and code should come out with the correct values. just be sure to draw in the negative direction inside of BobCAD.

    #16428

    Jason
    Participant

    Thank you.

    It was actually just a case of me expecting the worst. Once I created the tool path and posted to the machine it worked great.

    Thanks again,
    Jason

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

Forum Account

     Lost Password / Register   

Sharing

facebooktwittergoogle_pluspinterestlinkedinmail