Open Source Sofware

» Topic: vertical / horizontal milling V26

Home New Forums BobCAD-CAM Forums vertical / horizontal milling V26

This topic contains 2 replies, has 2 voices, and was last updated by  Frank 2 years, 7 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #16893

    Frank
    Participant

    Hello, I’m a new Bobcad user, wondering if somebody could help me with information how to set the software from vertical to horizontal milling.
    Thanks!

    #16897

    Sean
    Participant

    The software axis wise should be correct for horizontal machining. The way the software works is you can set the machine setup(Orientation of machining) to whichever plane you wish. In most cases, a horizontal uses the same axis as a vertical, just in a different visual orientation on the machine. There should be no need to change the software from vertical to horizontal because of this.

    #16946

    Frank
    Participant

    Thanks Sean!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

Forum Account

     Lost Password / Register   

Sharing

facebooktwittergoogle_pluspinterestlinkedinmail