Open Source Sofware

Will v26 PostProcessor work with v23, need pause for "z" change

Home New Forums BobCAD-CAM Forums Will v26 PostProcessor work with v23, need pause for "z" change

This topic contains 0 replies, has 1 voice, and was last updated by  solidworks4u 1 week, 4 days ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #33216

    solidworks4u
    Participant

    I would like to say Hi, 1st post am in need of post processor from v23 to (2 1/2 axes machine) to operate with Linuxcnc. I think there needs to be a way to configure a pause to allow for change in “z”. Any help would be greatly appreciated.

    many thanks!!

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.