Open Source Sofware

» Topic: z axis does not clear part when traveling to first point

Home New Forums BobCAD-CAM Forums z axis does not clear part when traveling to first point

This topic contains 1 reply, has 2 voices, and was last updated by  tmday7 1 year, 7 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #21242

    Rich
    Participant

    I have a homebuilt cnc running VA and Mach3. When I run my gcode, the z axis does not raise to clear the part,it stays at 0. I can’t remember if it’s mach3 or bobcad that I address this. Thanks!

    #21262

    tmday7
    Participant

    This needs to be done in BobCad.

    Troy

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Forum Account

     Lost Password / Register   

Sharing

facebooktwittergoogle_pluspinterestlinkedinmail