ParametersIn this Topic Show
The Parameters page of the Cutoff operation contains the variables needed for the feature.
ParametersThe Lathe Cutoff feature is used to cut off finished parts from the stock. This feature type only contains Cutoff operations. All of the cutoff parameters are explained next.
Cutoff Z - sets the position at which the cutoff occurs in the Z-axis.
Cutoff X - sets the position at which the cutoff occurs in the X-axis.
Rapid Clearance - is added to the stock diameter to provide a safe travel distance for rapid positioning.
Retract Amount - sets the distance that the tool retracts between each cut.
Stock Diameter - sets the major diameter of the bar stock being machined.
Off - does not break the corner of the cutoff.
Chamfer - breaks the corner of the cut part with a chamfer.
Chamfer Length - sets the length of the chamfer to be cut.
Chamfer Angle - sets the angle of the chamfer.
Fillet - fillets the corner of the cut part if this is set.
Fillet Radius - sets the radius of the corner on the cut part.
The following pecking parameters are available for (rough) Groove operations.
First Peck Amount - sets the amount of material removed during the first entry into the material.
Peck Clearance - sets the height above the material from which the tool speed changes from rapid to feed (for each peck).
Peck Increment - sets the amount of material that is removed by each pass performed after the first peck.
Peck Retract - sets the distance that the tool retracts between each peck.
When you are finished defining the Parameters for the operation, click Next> > to go to the Rapids page.