Workpiece

In this Topic Show

Introduction

This topic explains how to assign workpiece geometry for CAM jobs in BobCAD-CAM. This allows you to assign geometry that represents the workpiece, or the final part, to determine what displays in simulation window as the workpiece.


NOTE:      You do not have to assign a workpiece. To skip the workpiece assignment, just click the next button (RightArrowNextButton.png) to keep going through the Stock Wizard. If you do not assign a workpiece, all visible solid and surface geometry in the graphics area is passed to simulation as the workpiece geometry. Also, if you do assign a workpiece and that geometry is hidden when you launch simulation, no workpiece displays (the Workpiece button becomes unavailable).


Method 1) Assigning the Workpiece During the Job Setup

When you open the Stock Wizard from the Machining Job dialog box, the Workpiece selection dialog box displays as the first page of the Stock Wizard.

 

1      Under Define Workpiece, click Pick Solid Model.

 

2      Click or drag a window to select the workpiece geometry, which is the target part.

 

3      Click OKCheckmarkIconWhite.png OK to confirm the selection.

 

4      Click RightArrowNextButton.png to begin the Stock Wizard.

Note that you can modify the workpiece assignment, after completing the Stock Wizard, using the CAM Tree.

Method 2) Assigning Workpiece Geometry Using the CAM Tree

After creating a CAM job, you can assign workpiece geometry or modify the current assignment using the Workpiece item in the CAM Tree.

 

1      In the CAM Tree, right-click Workpiece, and click Re/Select.

 

Note that you can click Remove if you want to remove the current assignment.

 

2      Click or drag a window to select the workpiece geometry.

 

3      Click OKCheckmarkIconWhite.png OK to confirm the selection.

 

When you simulate the program, only the assigned geometry is passed to simulation as the workpiece.

 

Related Topic

Getting Started With Simulation

 

Next Topic

Once you are ready to go to the Stock Type page, click RightArrowNextButton.png.