Ream Parameters

In this Topic Show

Introduction

This topic contains the operational parameters found in the Hole Wizard for the Rolling Tap Operation.

Hole Groups - Important

When defining the parameters (the Parameters page of the wizard) for drilling operations, be sure to select a group in the Hole Groups list before changing the parameters. Then make sure to define the parameters for all groups in the feature. However, note that center drill and chamfer operations do not have a Hole Groups list as these operations automatically use the same parameters for all groups in the feature.

GearWizardIconGray.png Ream Operation Parameters

Operation Parameters

CheckBoxSelected.png Select the check box to use the values that are automatically calculated using the Cutting Conditions and selected feature parameters. This calculates the Overall Depth and Effective Depth for the operation.

CheckBoxCleared.png Clear the check box to manually change the values that were automatically calculated.

 

GearWizardIconGray.png MDI (Manual Data Input)

View the MDI topic.