Load
Image dialog
Introduction
When you load an image from the BobART Manager,
the image displays in the graphics area with the reference point (origin)
located at X0Y0Z0 by default. The origin for the image is the bottom-left corner
of the image. If you need to relocate the image in the graphics area,
you use the
Navigation
To access the
- In the
BobART Manager,
under 
Images,
right-click 
Image name,
and click Edit.
Load Image Dialog
Quick Access Menu
-
Apply - applies the updated changes. -
OK - applies the updated changes and exits the dialog. -
Cancel - discards the changes and exits the dialog. -
Blank/Unblank Images - hides and shows all images but leaves the image currently being edited visible. -
Blank/Unblank Emboss Model - hides and shows the current state of the canvas.
UCS
This group allows you to select from any of the User Coordinate Systems currently used in the file.
Origin
|
|
|
| This list box will show the entity currently selected to act as the origin. | |
The Origin group sets the image location using the XYZ coordinates. The origin is the bottom-left corner of the image.
-
X - determines the location along the X-axis of the
-
Y - determines the location along the Y-axis of the
-
Z - determines the location along the Z-axis of the
Orientation
This group allows you add a rotation angle to the image.
-
Rotation Angle - This value is applied with the Z axis of the Origin acting as the center of rotation. Positive values rotate the image counter-clockwise.
Size
- Keep Aspect Ratio
Keeps the X Size and Y Size values relative to each other. When one value is adjusted, the other automatically adjusts to keep this ratio intact.
Will allow the ratio to be skewed so the X Size and Y Size values can be adjusted independently. - X Size - sets the length of the image along the X Axis.
- Y Size - sets the width of the image along the Y Axis.
Transparency
This group allows you to specify the transparency of the currently edited image from 0 to 1, with 1 being completely transparent.
