Point Pattern
Introduction
This topic will explain where to find the Point Pattern function, and explain the options found in it. This topic will also give quick steps, and provide links to related topics.
The Point Pattern Function
The Point Pattern function is used to group a set of points or arcs so that they can be selected as a single entity (point pattern), usually for machining purposes.You can select any combination of points and/or arcs. When you select points, the software creates an arc at that point, using the Hole Radius value, for each point. When you select arcs, they are changed to the Hole Radius value and the center point is added. After creating the pattern, it can be selected as a single entity.
Navigation
To open Point Pattern:
-
In the Pattern group, of the Create 2D ribbon, click
Point Pattern.
The parameters display in the Data Entry Manager.
The Data Entry Parameters
Selected Geometry
|
|
|
| The list will display all entities currently selected for the function. | |
(Delete) - removes
the highlighted item from the Selected Geometry list.
(Delete All)
- removes all entities from the Selected Geometry list.
-
Hole Radius - sets the radius of the arcs created from the selected points. If arcs are selected, they are changed to this value.
- OK - performs the function as shown in the preview.
- Cancel - cancels the function when finished.
Quick Steps - Point Pattern
- Select the geometry to become a point pattern.
The geometry is added to the Selected Geometry list. - Set the Hole Radius to use for the point pattern.
- Click OK to create the point pattern.
- Click Cancel to exit the function.
