Cutoff Parameters
Introduction
The Parameters page of the Cutoff operation contains the variables needed for the feature.
Parameters
Lathe Cutoff Feature - Operation Parameters
The Lathe Cutoff feature is used to cut off finished parts from the stock. This feature type only contains Cutoff operations. All of the cutoff parameters are explained next.
Parameters
- Cutoff
Z - sets the position at which the cutoff occurs in the Z-axis.
- Cutoff
X - sets the position at which the cutoff occurs in the X-axis.
- Retract Amount - sets the distance that the tool retracts between each cut.
Corner Break
- Off
- does not break the corner of the cutoff.
- Chamfer
- breaks the corner of the cut part with a chamfer.
- Chamfer
Length - sets the length of the chamfer to be cut.
- Chamfer
Angle - sets the angle of the chamfer.
- Chamfer
Length - sets the length of the chamfer to be cut.
- Fillet -
fillets the corner of the cut part if this is set.
- Fillet Radius - sets the radius of the corner on the cut part.
Pecking
- No pecking is done during cutoff.
- Gives you access to the following pecking options.
- First
Peck Amount - sets the amount of material removed during the
first entry into the material.
- Peck
Increment - sets the amount of material that is removed by
each pass performed after the first peck.
- Peck
Clearance - sets the height above the material from which the
tool speed changes from rapid to feed (for each peck).
- Peck Retract - sets the distance that the tool retracts between each peck.
Next Topic
When you are finished defining the Parameters for the operation, click Next> > to go to the Rapids page.