Patterns
Introduction
This topic explains the Patterns page of the Z Level Rough operation found in the Mill 3 Axis Wizard.
Patterns
Cut Pattern
-
Pocket In - the cuts occur from the outside towards the inside of the model.
-
Pocket Out - the cuts occur from the inside towards the outside of the model.
Cut Direction
-
Climb Mill - the tool travels in a counter clockwise direction along the inside shapes of the model and travels in a clockwise direction along the outside edges of the model.
-
Conventional Mill - the tool travels in a clockwise direction along the inside shapes of the model and travels in a counter clockwise direction along the outside edges of the model.