Patterns
Introduction
This topic explains the Patterns page of the Z Level Rough operation found in the Mill 3 Axis Wizard.
Patterns
Cut Pattern
-
Pocket
In - the cuts occur from the outside
towards the inside of the model. -
Pocket
Out - the cuts occur from the inside
towards the outside of the model.
Cut Direction
-
Climb
Mill - the tool travels in a counter
clockwise direction along the inside shapes of the model and travels
in a clockwise direction along the outside edges of the model.
-
Conventional Mill - the tool travels in a clockwise direction
along the inside shapes of the model and travels in a counter clockwise
direction along the outside edges of the model.
