Cutsim

The CutSim tab provides parameters for the material removal.

Save Stock

The resulting stock model can be saved to an .stl file (during or after the machining).

Advanced parameter

It is possible to save the stock geometry after each operation. When you select the check box the files are stored in the folder you specify.

Data Model

The data model can be automatic, 3 axis or 5 axis.

• The automatic set the right mode suitable for the simulated part.

• The 3 axis model is meant to be used for 3 axis machining in Z without undercuts.

• The 5 axis allows undercut material removal.

Accuracy

The accuracy is the resolution of the stock model. A low accuracy brings more speed but a less accurate result. A high accuracy slows the machining process down, therefore the resolution of the stock model is accurate.

Check

The check option handles whether a part of a tool should remove the material, be gouge checked, do both or do nothing.

Flute

• • Cut - Only material removal, no gouge checking.

  • Cut and collision check (rapid moves) - Material removal and gouge checking.

Shaft, Arbor and Holder

• • None - No material removal, no gouge checking.

  • Cut - Only material removal, no gouge checking.

  • Cut and collision check - Material removal and gouge checking.