The Add/Modify Thread Dialog Box
Introduction
When you click Add Thread or Modify Thread from the Thread Library dialog box, the Add/Modify Thread dialog box is displayed for you to create or modify the thread parameters. These parameters are explained next.
Navigation
To open the Add/Modify dialog box:
- In the Thread Library dialog box, click Add Thread or Modify Thread.
The Dialog Box Parameters
Thread Type
-
Tap Label - is the name of the tap that displays under Thread Type. This name is shown when you select this thread type for a tapping operation.
-
Nominal Diameter - sets the nominal diameter of the thread.
-
Small Pitch Diameter - sets the small pitch diameter of the thread.
-
Pitch - sets the pitch of the thread.
-
Angle - sets the angle of the thread.
Hole Sizes
-
Cutting - is the size of the drill used for this Thread Type when you select a cutting tap tool.
-
Rolling - is the size of the drill used for this Thread Type when you select a rolling tap tool.
After defining all of the parameters, click OK to update the thread parameters in the Thread Library.