Gear
Introduction
The Gear function creates a gear based on the settings that you define
in the Data Entry Manager.
Snap Increment
Gear supports the use of the snap increment when using the Pick method
to set the origin location. The snap increment allows you to get precise
results when using mouse selection and helps to reduce data entry modifications.
To learn more, view Snap Increment.
The Data Entry Parameters
- Number of Teeth - sets
the number of teeth
on the gear.
Pressure Angle (1)
- sets the angle of the gear teeth. Pitch
(4) - sets
the pitch of the gear. Outside Diameter
(3) - sets the greatest diameter of the gear. Root Diameter
(6) - sets
the inside diameter of
the gear. Root Fillet Radius
(5) - sets
the radius formed between the individual teeth and the Root
Diameter. Tooth Corner Radius
(2) - sets
the radius formed at the end of the gear tooth.
|
 |
Origin
Pick
- enables selection mode for you to select geometry to define the
origin location. The snap increment applies when using this option.
Enter
- type values in the X, Y, and Z
boxes to define the origin location in reference to the active
UCS.
- OK - performs the
function when using the Enter method to set the origin.
- Cancel - closes the Data
Entry Manager.
Related Topics
How
to Create a Gear